7
Upgrading to Cisco IOS Release 12.2(28)SB on a Cisco 10000 Series Router
OL-8833-01
Upgrade Option 3: ESR-PRE1 Upgrade with RPR Switchover
•
If the ESR-PRE1 config-register is set to 0x0, it will boot to ROM monitor. Boot the ESR-PRE1
image from ROM monitor and wait for to come up as standby in RPR mode with the console
disabled.
•
If the ESR-PRE1 config-register is set to 0x2 and the autoboot string is set to boot the ESR-PRE1
image, it will come up as standby in RPR mode with the console disabled.
Note
From the ESR-PRE1 console and the ESR-PRE2 console, you may see error messages such as
Failed
to assert Cutover alarm RP A/or B
or
outgoing IPC bypass failed
. You can ignore these messages.
because they do not affect operation of the system.
Note
Now you should test the 12.2SBB image to determine whether or not a rollback to the previous image is
needed. To roll back, see the
“Rollback Procedure for Option 3” section on page 7
.
Step 12
After you have verified correct operation of the ESR-PRE2, replace the standby ESR-PRE1 with a
second ESR-PRE2. Bring it up and load the new image onto bootflash as follows:
a.
From the newly installed ESR-PRE2 boot image console, copy the 12.2(28)SB image from the TFTP
server to the bootflash using the
copy tftp bootflash
:
image_name
command.
b.
From the newly installed ESR-PRE2 console, use the
dir bootflash
command to verify that the
12.2(28)SB image is in the bootflash. Configure the ESR-PRE2 to autoboot using the
boot system
bootflash
:
mage-name
and
config-register 0x2
configuration commands. Save the configuration
using the
write memory
command.
Step 13
Reload the second ESR-PRE2. It will autoboot the new image from the bootflash and come up as the
standby. The console will display the following messages:
PRE2>
Standby console disabled
PRE2>
Standby console disabled
At this point, the system should be operating as a dual-PRE redundant 12.2(28)SB system in the
configured mode (either SSO or RPR+), running the properly modified startup configuration. You can
verify the redundancy status using the
show redundancy
or
show redundancy state
command.
Step 14
Enter the
write memory
command from the active console to bring the startup configuration up to date
on the active and standby ESR-PRE2s.
Rollback Procedure for Option 3
If the active ESR-PRE2 does not operate satisfactorily after
Step 11
, you can initiate a second switchover
to revert to the original ESR-PRE1 operating as the active processor. You must do so before you perform
Step 12
.
To change back to the ESR-PRE1:
Step 1
Make sure the ESR-PRE1 is up as the standby PRE (see
Step 11
).
Step 2
Remove the active ESR-PRE2 from the chassis. Service will be disrupted as the standby ESR-PRE1
becomes the active standalone.
