VCC-F40X34
Rev.900-676-32-00
©2010 CIS Corporation. All rights reserved.
14
8. Remote Interface Function
Through RS-232C interface, the camera can be controlled by external PC.
(1)
The settings for RS-232C
(2)
Control code
・
The total control code is 14 bits, which conforms to ASCII code.
・
The control code consists of camera No. process code, remote controller address, remote controller
data, and CR. Execute Read/Write through PC, and the camera will reply the data.
1 2 3 4 5 6 7th
Byte
8
9
10
11 12 13 14
Camera No.
Process code
Remote controller
address
Remote
controller data
CR
00000: Common to the all
cameras.
Individual camera No.
“R” Read mode
Please refer to the
address table of
5. Function settings
000
～
255
0 Dh
“W” Write mode
“C” Camera
mode
Camera No. shall consist of 6 bytes of characters/numeric strings.
Send the individual camera number code or common number code, “000000”.
The reply data from the camera shall contain the registered number for that camera.
Process code
Input any one of R, W, or C to the process code.
R (read mode) is to read the data of remote controller address.
Please be noted to set any dummy data (000
～
255) to 11
th
～
13
th
, since a command shall consists
of 14 bytes.
W (write mode) is to write the data to the remote controller address.
Please be noted that the data cannot be saved into EEPROM of the camera.
(Reboot the camera, and the data is reset to the initial setting.)
To save the data into EEPROM, please refer to Clause 5. Function Settings.
C is the code to send the data back from the camera.
Note: Do not set code C when sending the data from PC side.
Baud rate
:
9600bps
Data :
8bit
Stop bit
:
1bit
Parity :
None
XOn/XOff :
Not controlled
