![background image](http://html1.mh-extra.com/html/cis/vcc-2cxp6r/vcc-2cxp6r_product-specification-and-operational-manual_2608738021.webp)
VCC-2CXP6R
Rev.905-0187-02
©2019 CIS Corporation. All rights reserved.
18
5.14.
Manual Shutter Settings with CLK Sync. Mode (FAST Trigger Mode)
Exposure time = Setting value +
4.997μ
s
・
Min. setting value: 10
μ
s (Approximate value)
・
Max. setting value: 200ms (Approximate value)
※Unlike H sync. mode, clipping shall not be executed by total line count, etc.
※Bright point may be noticeable at long time exposure.
・
Setting unit
:1μs (Approximate value) ※Slight differences may occur since it is generated by 74.25MHz clock.
5.15.
Gain
AnalogControl
Gain
Manual
x1.00 to x256.00 preferred Gain can be set.
Functionally, up to 256 times of the value can be set. However, image degradation cannot be avoided when
high gain is set. We recommend you to evaluate it first.
5.16.
Gamma Correction
□
This is to execute gamma correction.
AnalogControl
Gamma
Settings for the coefficient of 0.10~1.80
Gamma : This is to set the gamma correction value per 0.01step.
[Note] Gamma table shall be updated at image output timing. It shall be applied at image output after the
completion of rewriting the gamma table (Approx. 20ms: Command ACK is the rough standard.) at
continuous operation mode. In case the gamma coefficient is changed while waiting trigger to be
input, the gamma updated image shall be output with the trigger after the completion of rewriting the
table.
5.17.
Partial Scan (ROI)
□
This is to increase its frame rate by cutting out and reducing the read out area.
□
This function cannot be used with 2×2 Binning mode (Only for monochrome model).
□
It shall be Idle output in case the RegionMode of Region 1~8 is all off.
□
Max. 8 partial areas can be set.
ImageFormatControl
RegionSelector
EffectiveRegion, Region1~8
RegionMode
On/Off
RegionDestination
Stream0
Width
1632
Height
8~1248 (Multiples of 8)
OffsetX
0
OffsetY
0~1240 (Multiples of 8)
・
RegionSelector : This is to select the region to be set. 8 partial areas can be set with Region1~8.
Width and Height of the effective partial area can be checked by selecting EffectiveRegion.
※ Please do select EffectiveRegion to start acquiring images.
※ Please do select EffectiveRegion when selecting 2×2 binning mode (Only for monochrome model).