VCC-2CXP6R
Rev.905-0187-02
©2019 CIS Corporation. All rights reserved.
21
BalanceRatio
: This is to set the gain by the range of x0 ~ x8.
When setting BalanceRatio to 1.0 after setting BalanceRatioSelector to Blue, then set BalanceRario to 1.0 after
setting BalanceRatioSelector to Red, white balance shall be invalid.
5.19.
Black Level Adjustment
□
This is the function to adjust black level of image sensor.
[Note]
This function is not the function to set the absolute value of black level.
This function can change the black level settings of the image sensor relatively.
This is the value converted to 12bit. In case of 10bit, the value shall be equivalent to ±16, and in
case of 8bit, the value shall be equivalent to ±4.
Settings can be changed while capturing images. However, image may be distorted.
5.20.
Image Quality Selecting Mode
□
This is the function to select the quality of output image.
Image Quality Mode: Image quality selecting mode
StandardMode: Standard mode
LowNoiseMode: SN shall be improved compared to StandardMode, however the sensitivity shall be
decreased.
LowFrameRateMode: SN shall be improved more compared to LowNoiseMode, however the frame rate and the
sensitivity shall be decreased. Valid only at Mono8 and BayerRG8.
5.21.
Defective Pixels Correction
□
This is the function to detect and correct the pixel defects in the data output from the sensor.
□
Data are categorized into two types and controlled.
・
Data at Ex-Factory
The detected data of white pixel defects and black pixel defects at Ex-Factory are saved.
Basically, these data cannot be erased.
・
Data registered by users
Data increased after shipment or the one registered by users.
These data can be entirely erased anytime by DefectPixelDefault.
AnalogControl
BlackOffset
-64~63
AnalogControl
Image Quality Mode
StandardMode
LowNoiseMode
LowFrameRateMode
