VCC-V90S Rev.900-625-30-00
⑨
Imaging system
Image sensor is installed.
⑩
Lens Mount
C/CS mount lens
When installing C mount lens, adjut C/CS mount to C and install.
Lens size: screw length 6mm or less from lens mount, stick out must be less than 9.8mm for C mount lens, and less than
4.8mm for CS mount lens.
⑪
Mounts for Tripod
To install a camera on a tripod.
⑫
Mount lock screw
⑬
Mount adjutment screw
This is used to switch C/CS mount, flange back adjustment and setup. Please set this before mounting a lens.
C/CS mount adjust steps
Please not that if C mount lens is installed while having a CS Adjust setting, lens or camera could be damaged.
Setup:
(1) Move Lock counter clockwise and unlock
(2) Move Clockwise for C mount counter clockwise for CS mount, then install lens and adjust back focus.
(3) When done, move Lock clockwise to lock it.
⑭
DC IRIS connector
4pinconnector for DC IRIS
pin
1 DAMP-
2 DAMP+
3 DRIVE+
4 DRIVE-(GND)
When using DC IRIS, use command to enable it, otherwise aperture will be opened.
When AES(AUTO SHUTTER) and DC IRIS are both enabled, AES will work first then DC IRIS will work when the
environment becomes brighter.
Do not use MANUAL SHUTTER
slow side (1/15
～
2sec) and DC IRIS at the same time. DC IRIS will cause hunching.
©2008 CIS Corporation. All rights reserved.
12
