CR:112A & CR:112AIS doseBadge User Manual
Page 16
Switching on the Reader Unit
Press the Power button on the Reader to switch on. The
Reader will power on and will display the start screen.
The Reader unit will automatically switch off after 4
minutes of inactivity.
The backlight of the display will switch on when any key
pressed and will automatically switch off after 10 seconds
to preserve battery power.
Checking the configuration
Before making a measurement with the doseBadge system, ensure that the
configuration of the parameters listed below are as required to meet the
regulations or guidelines for which the measurement are being made.
Cirrus Research plc accepts no responsibility for the accuracy of measurements made
where the configuration of the doseBadge and Reader unit is not correct for Local,
National or International Regulations.
If you are in doubt about the correct settings for your system, please contact your local
Cirrus Research representative or contact Cirrus Research plc directly.
Please note that the RC:112A Reader Unit is not compatible with the CR:100A,
CR:100B or CR:110A versions of the doseBadge. If the user attempts to
program a CR:100A or CR:100B doseBadge with an incorrect configuration, an
error message will be displayed as shown below.
Clock (Time & Date)
The RC:112A Reader unit has a clock and calendar which is used to stamp the
measurement with the current time and date. It is vital that the time and date of the
clock in the Reader unit is correct.
The current time and date is displayed at the bottom of the
display. If the Clock has not been set, the Reader unit will
show "Clock not set".
The current Time and Date are shown at the bottom of the
display. If the Time and Date are not correct, press the OK
button to enter the Clock Set menu.
