Circutor DHB-402, Instruction Manual

Page: 22 / 60

4�7�2�3�- EXPECTED VALUES (Yi)
This screen is used to configure the value Y1 (expected value) corresponding to the first point in the
equation. The screen flashes between the symbol and the configured value (
Figure 21
).
...
Figure 21:Expected values configuration screens�
To edit the parameter, press the button.
To modify the value of the selected digit, press the button repeatedly.
To jump to the next digit, press the button.
Once at the desired value, validate by pressing the button.
You can now select the position of the decimal point, which will be flashing.
To select the position of the decimal point, press the button.
Validate by pressing the button. The unit will go back to the screen shown in
Figure 21
.
To move to the next parameter on the menu, press the button.
When the button is pressed, the unit goes to the main screen of the regression of non-linear equa-
tions menu (
Figure 18
).
Range : -19999 ... 99999
Default value: 0
Note: The configuration screens “
4.7.2.2 MEASURED VALUES (X)
” and
“4.7.2.3.- EXPECTED VALUES
(Yi)
”
must be repeated once for each number of points programmed.
Note:
All the measured points (Xi) must be in sequence such that X1 < X2 < ... < Xi. If this is not the case,
regressions of non-linear equations will be disabled and an indicator established in the log.
4�7�2�4�- EXITING THE MENU
At the end of the menu the screen shown in
Figure 22
appears �
Press the button to go back to the regressions of non-linear equations main screen
Figure 18
�
Figure 22:End of menu screen�
22
DHB-402 DHB-424
Instruction Manual