Circutor DHB-402, Instruction Manual

Page: 19 / 60

4�7�1�2�- COMPENSATION VALUE
Note:
Parameter applicable to temperature (RTD and Thermocouple) and resistance measurement in-
puts.
This configuration screen is used to select the compensation value.
For the RTD sensors this value is defined by the cable that joins the RTD sensor to the unit.
For the thermocouples it is defined by the cold junction .
The screen flashes between the symbol and the configured value. (
Figure 15
).
Figure 15: Compensation value screen�
To edit the parameter, press the button.
To modify the value of the selected digit, press the button repeatedly.
To jump to the next digit, press the button.
Once at the desired value, validate by pressing the button.
You can now select the position of the decimal point, which will be flashing.
To select the position of the decimal point, press the button.
Validate by pressing the button. The unit goes back to the screen shown in
Figure 15
To move to the next parameter on the menu, press the button.
When the button is pressed, the unit goes to the main screen of the input parameters menu (
Figure
13
).
Range: RTD temperature or resistance measurement input : 0 ... 20 Ω.
Thermocouple temperature input
: 0 ... 60ºC.
Note: If a value is programmed that is out of range, the unit will activate automatic compensation.
Default value: 0.
4�7�1�3�- MEASUREMENT TIME
This screen lets you configure the measurement time for the input signal in seconds.
The screen flashes between the symbol and the configured value (
Figure 16
).
Figure 16:Measurement time display screen�
19
Instruction Manual
DHB-402 DHB-424