4.7.- CONFIGURATION
In the setup menu you can:
Program the weight and type of impulse output
Program the communications.
Program the display screen.
Program the cost of the energy and the CO
2.
emissions
Delete the partial energy meters.
The standby mode is activated again when no button is pressed for 60 seconds.
Long press the
button in the standby mode screen to open these setup screens. Short
press the button to display the home screen,
Figure 11: Programming home screen
Long press the
button to access the first programming step.
4�7�1� Impulse output weight
This is the home screen for entering the weight of the impulse
output.
Long press the button to view the value to be programmed.
To write or modify the value, short press the
button
repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit with a long press on
the
button, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the
button; the validation screen
will appear (
) indicating that the programming value has been saved.
21
Instruction Manual
CEM-C20
