Circutor AFQm IP54, Instruction Manual

Page: 94 / 174

94
AFQm IP54
Instruction Manual
ENGLISH
When unloading and moving the device, use a forklift with forks long enough to support the entire
length of the base. Otherwise, the forks should be long enough to support at least ¾ of said depth. The
forks must be flat and supported firmly by the base. Raise the device by placing the forks underneath
the profile that supports the device. (
Figure 2
).
There might be an offset in the centre of gravity from the centre of the cabinet,
as a result of the uneven distribution of loads inside the device. The necessary
precautions must be taken to prevent the device from tipping over during abrupt
operations.
Figure 2: Unloading with a forklift.
When unpacking the device, pay attention to prevent damaging the device if you are using cutting
tools, such as cutters, scissors or knives.
The AFQm IP54 devices cabinet type, there are also 4 rings (diameter : 28 mm) in the top panel so that
they can be transported by a crane. The top panel is inverted, but the rings are mounted, to enable it
to be transported without any prior set-up required. The angle of the cables must be greater than 45º
Figure 3: Transport of an cabinet AFQm IP54 by crane.
1.3.- STORAGE
The device should be stored, with its original packaging, according to the following recommendations:

Avoid placing them on uneven surfaces.

Do not store them in outdoor areas, humid areas or areas exposed to splashing water.

Avoid hot spots (maximum ambient temperature: 50ºC)

Avoid salty and corrosive environments.

Avoid storing the devices in areas where a lot of dust is generated or where the risk of chem-
ical or other types of contamination is present.