Circutor AFQm IP54, Instruction Manual

Page: 122 / 174

122
AFQm IP54
Instruction Manual
ENGLISH
5.- START-UP
When the device has been powered the screen in
Figure 27
appear on the display.
Figure 27: Home screen.
Before starting the active filter, it is necessary to follow the steps below:
1.- Go into the configuration screens, and set up the device as required for the existing installa-
tion.( See
“7 - CONFIGURATION”
).
2.-
(
Device
“single”
or
“master”
)
Go into the numeric values screens, , and on the screen that
shows the voltage and current (
“6.2.5 - VOLTAGE / CURRENT / FREQUENCY”)
:

Make sure the
voltage
measurements correspond to the real voltages of the installation.

Make sure the load
current
measurements correspond to the current levels of the installa-
tion.
3.-
(Device
“single”
or
“master”
) Go into the numeric values screens, , and on the screen that
shows the load parameters (
“6.2.7 - POWER AND COS ɸ OF LOAD”
):

Make sure the
active power
measurement of the load corresponds to the active power levels
of the installation.

Make sure the reactive power measurement of the load corresponds to the reactive power
levels of the installation.

Check the cos
ɸ
in the three phases. If phases appear with very high reactive power and very
low active power levels, this may indicate an error in the phase order. In this case, check the
power supply and current input connections.
4.-
(Device
“single”
or
“master”
) Go back to the home screen of the device, ,
Figure 27
, if there is
no problem with the connections, the upper area should show the message “ Stop” .
If there is a problem with the filter connections or the configuration, the
“Waiting for conditions”
message appears.
5.- (Device “single” or “master” ) Press the key to start the active filter. If it has started correctly,
the screen will show the message “ Run ”.