3.Stop And Run The Pump
3.1 Start the Pump
1) Make sure the pump is connected with electricity. When power is on, the display screen will
display the time.
2)
Press one of
ECO/CLEAN/BOOST, the pump will run. The light on the corresponding
program will be lit. No matter what program you select, the pump will run on 2850RPM for 5
minutes to eliminate the air in the pump, so the impeller will not dry grind thus to cause leakage.
After high-speed running, the pump will run the default speed of the selected program.
3.2 Stop the Pump
Press STOP of the running pump, the pump will stop. The lights on the screen twinkle.
3.3 Change Pump Running Speed
1) When the pump is running ECO/CLEAN/BOOST, press arrow buttons up or down to change
the speed, each press is for 50RPM. It will save automatically, no need to press ENTER.
2) Switch ECO/CLEAN/BOOST during pump operation, the pump will not run 5 minutes high
speed again.
3) For MODE 1 and MODE 2, to change speed of S1 and S3, first press CLEAN, if not
work, you will need to stop the pump first. After 5 minutes high speed running, press
CLEAN, then press arrow button to increase or decrease RPM. When press MODE 1 or
MODE 2 again to run the pump, S1 and S3 will run as just selected.
To adjust S2 and S4, first press ECO, if not work, you will need to stop the pump. After
10 minutes high speed running, press ECO, then press arrow button to increase or decrease
RPM. When press MODE 1 or MODE 2 again, S2 and S4 will run as just selected.
8
10
7
8
4
3
2
1
5
9
6
