Cineversum R599870, User Manual

Page: 9 / 44

INSTALLATION GUIDELINES
R599870 - Force 4K User Manual 9
Space requirements
30 cm
30 cm
15 cm
20 cm
Space requirements: 15 cm above this unit, 20 cm at the rear and 30 cm on the left and right sides.
At the front of this unit
Leave the front area of the unit unblocked. If there is any obstructing object in front of the exhaust vent, hot air
will flow back to the unit and cause it to heat up. Hot air flowing out of the unit may cast shadows on the screen
(heat haze phenomenon).
2.4 Installing the projection screen
Install the projection screen and this unit such that they are perpendicular to each other as showed in the picture
below.
Place this unit perpendicular to the screen.
Use the electronic shift and zoom to correct the picture size and position as needed. You can also use the
feet to adjust the projected picture level.
Screen material suitable for 4K projection.
To optimize the sharpness and detailing of the picture, please choose a screen material optimized for ultra High
resolution (UHD 4K). Avoid any material with uniform patterns as checks that may cause interference artefacts to
occur. If this is the case, you can try to slightly change the size of the projected image to make the interference
patterns less noticeable.
2.5 When to use the High altitude mode
When using this unit at a location that is higher than 900m above sea level and making the air pressure low
enough to decrease its efficacity cooling this unit, set the “High Altitude Mode” to “On”.