Cineversum R599870, User Manual

Page: 29 / 44

INSTALLATION
R599870 - Force 4K User Manual 29
Charging the 3D Glasses
The 3D Glasses come with a USB rechargeable battery that is charged using the USB to micro USB cable.
Connect the cable to the micro USB slot (E). The indicating LED (A) will light On red continuously during the
charge. The glasses are fully charged when the indicating LED (A) switches Off.
Turning On your 3D Glasses
• Press the Power Button (B) once.
• The indicating LED (A) will light On and the Optical Lenses (C) will blink alternately left and right to indicate
that they are ready to synchronize with the 3D synchro emitter.
Turning Off your 3D Glasses
To turn Off the glasses, press and hold the Power button (B) for 3 seconds until the indicating LED (A) switches
Off.
3D Glasses battery level
The battery allows up to 75 hours of continuous power. A low power level, below 30%, is indicated by a single
flash of the Indicating LED (A) at the 3D glasses switch On. Power level between 30% and 90% is indicated by 2
flashes. 3 flashes indicates that the power is above 90%
Auto Power Off
The 3D Glasses are programmed to automatically stop functioning after 5 minutes of immobilization or 10 minutes
without a 3D synchro signal. To turn them back On, just press the Power Button (B) once.
10.0 InsTallaTIon
10.1 Installation Mode
An Installation Mode is a memory slot that collectively manages the setting values of “Lens Control”, “Pixel
Adjust”, “Mask”, “Anamorphic” and “Screen Adjust”. There are a total of 10 Installation Modes.
Mode Select
Selects a specific memory amongst the 10 available. Setting values can be set from Mode 1 up to Mode 10.
Name Edit
Each Installation Mode can be renamed using “Name Edit”. You can use up to 10 characters that can be alphabets
(upper or lower case), numeric characters and/or symbols.
Mode Copy
The Mode Copy can be used to easily duplicate a selected Mode into the current Mode. Select the mode to copy
to and press the [OK] button to confirm.
10.2 lens Control
Focus / Zoom / Shift
Adjust the lens focus / Zoom or Shift to obtain a clear picture.
Image Pattern
If set to On, an internal pattern will be generated to adjust the current setting. If you want to use an external
generator, turn this option to Off.
Lock
Once the Lens is correctly set, you may lock this setting menu by turning the Lens control Lock to On. Any attempt
to access the Lens control menu will lead to the display of a warning message.
Lens Center
Reset the lens position to the original, central position.