4600 N. Mason Montgomery Road
·
Mason, OH 45040
800
-
677
-
0076
·
Fax: 513
-
923
-
5694
www.CinInd.com
·
A Subsidiary of The Armor Group, Inc.
Version 1.04
October 2014
Page 12
Daily Start
-
Up
1. Turn on power at customer
-
provided Disconnect Switch. Electric or gas
booster will be connected to a disconnect separate from washer
2. Turn on washer’s Main Power Switch. The white “Power On” indicator will
light.
3. Ensure that the drain valve is in the closed position.
4. Close door to begin automatically filling the tank. The unit will stop filling
the tank when the proper level is reached.
5. Turn on the Wash Heat Switch to activate the steam heat coil in the wash
tank.
Note
: When washer is connected to central exhaust
system, means must be provided to prevent the
exhaust of moist air during the operation of the washer.
Sequence of Operation
1. Set the wash temperature controller, located on the front of the main control
panel, to 160°F / 71.1°C (See temperature controller manual for setting
instructions).
2. When the temperature for the wash tank reaches the 160°F/71.1°C set
point, the washer door can be opened and the racks can be loaded.
3. Adjust the Cycle Time Switch to the light, medium or heavy soil position
depending soil conditions.
4. Push the green Cycle Start Button to begin wash cycle. The red In Cycle
Indicator will light, and stay lit until the cycle is complete.
5. Unload washer after In Cycle indicator goes off and wash cycle ends.
Detergent
When the solution reaches operating temperature, add the proper amount of
cleaning compound at the rate recommended by your chemical supplier. If the
detergent is in a powder form, pour the powder in the filter baskets, then close
the door and run the pump until all compounds have been dissolved. If the
compound has been broken up or partially dissolved, this operation will go
faster.
Notes
: Use of an automatic detergent dispenser is
recommended. To insure economical use of the
compounds, be sure that the sensing probes are kept
clean of any foreign matter. Consult your cleaning
compound supplier for recommendations. To obtain
satisfactory cleaning, we cannot stress enough the
importance of the proper detergent. The temperature
controller is located in the control panel.
Caution
: The cleaning compound should be the non
-
foaming type and should not contain a chemical
substance that will damage copper or aluminum.
WASH TEMPERATURE
RINSE LINE TEMPERATURE
160
°
POWER
OFF
ON
CYCLE
STOP
CYCLE
START
IN
CYCLE
CYCLE TIME
LT MED HVY
WASH HEAT
OFF
ON
160
°
POWER
ON
KS-70 R
ACK
W
ASHER
S
EQUENCE
OF
O
PERATIONS
