4600 N. Mason Montgomery Road
·
Mason, OH 45040
800
-
677
-
0076
·
Fax: 513
-
923
-
5694
www.CinInd.com
·
A Subsidiary of The Armor Group, Inc.
Version 1.04
October 2014
Gauge Panels
Install gauge panel and related temperature and
pressure probes.
1. Attach panel to chamber on studs provided.
2. Install probe from wash temperature gauge into
bracket provided in tank.
3. Install probe from rinse temperature gauge into
fitting on external rinse manifold.
4. Install fitting on wash pressure gauge tubing into
tapped hole on wash pump.
5. Install capillary tube from temperature control into
bracket next to wash temperature probe.
Exterior Piping
Install exterior rinse piping assembly (and booster
heater when provided).
1. Place booster heater, when provided, in required
position.
2. Attach external rinse piping assembly to nipple
extending through chamber wall. Attach rinse
solenoid coil to valve on piping assembly with
clips provided.
3. Steam booster heater option
-
Attach water inlet,
steam inlet and condensate piping assemblies to
booster heater. Attach rinse booster solenoid coil
to steam valve. Attach piping assembly between
booster and external rinse manifold.
4. Electric and gas booster heater option
-
Attach
piping assembly between booster and external
rinse manifold.
5. Verify that all rinse water and steam connections
are tight.
Exhaust Fan
Install exhaust fan and draft inducer. Position fan
assembly and attach with gasket and hardware
provided. Draft inducer must be installed in exhaust
stack above draft hood by customer. Connect the
flexible conduit provided to each motor and attach
leads.
Caulk
Caulk cabinet and trim sealing strip. Caulk around
base of machine between tank and floor and between
tank and cabinet. After initial start up, caulk as
required, to eliminate leaks. The sealing strip used at
housing seams will tend to extrude out during the first
few weeks of service. This can be trimmed back with
a utility knife.
Page 08
KS-70 R
ACK
W
ASHER
A
SSEMBLY
OF
W
ASHER
AND
A
UXILIARY
E
QUIPMENT
