20
SYNCHRONIZING KEY FOB REMOTE TRANSMITTER AND RECEIVER:
1. Start with the power on the MA4 off (engine key in the “OFF” position).
2. Press and hold the key fob remote “POWER” button for 10 seconds until both LED’s flash together, then
release. This signifies that the transmitter is in teach mode.
3.
Turn the MA4 engine key “ON”. The LED lights on the key fob remote will stop flashing after a few
seconds. Synchronizing is complete. You can confirm that the key fob remote is communicating with the
electronic control unit by observing the “Wi-Fi” icon on it’s display changing from red in color to blue.
USING THE TIP CONTROLER:
While the key fob remote transmitter is intended to be used from inside
the truck, the tip control panel is convenient to an operator working
near the back of the MA4 trailer. It is important to know that one can
override input form the other, so communication is crucial between
crew members when starting and stopping application.
A) Use the “START” and “STOP” buttons to begin and end
application of sealant material through the application spray bar.
B) The buttons numbered “1” through “5” (green/red lights) control
which spray nozzles are active on the application spray bar while
applying sealant material.
C) Pressing a numbered button will activate and turn on (green light)
or off (red light) a particular nozzle. Turning a nozzle “ON” can be
done “on-the-fly” while in application mode.
D)
IMPORTANT:
Due to the hydraulic pressure system, to turn “OFF”
a particular nozzle while in application mode you must press the
“STOP” button momentarily to reset the hydraulics and halt
application, then press the “START” button again to continue
application with the new nozzle setting.
Receiver
MA4 Key Fob Remote Transmitter Pairing
Key Fob Remote
Power Button
Crew communication is crucial to safety when
applying hot sealant material. Severe injury can
occur if the unit is activated unexpectedly.
WARNING
