|
15
Chapter 4 – usInG the Cm 9.3 a (+)
4.5 Initializing a sensor
The CM 9.3A (+) is a digital computer using the ANT+ transmission system. Every new sensor hast to be
initialized before use. Sensors will be stored until the battery is removed. The CM 9.3 A only supports ANT+
Sensors.
Please refer to 3.7.1 for how to initialize sensors.
If you have two bikes, you can connect designated sensors for each bike.
However, only one heart rate sensor can be initialized.
4.6 CICLO
InZone
®
CICLO
InZone
®
is a solution for the very best personalization of your training routine. It is possible to calculate
the optimum training threshold with the CICLO
InZone
®
function based on your personal data and your
resting heart rate. CICLO
InZone
®
is the ideal solution for personalized cardio training applied to any sport,
from jogging and cross-country running to road and indoor cycling.
Improve your fitness? – Lose weight? – Train whilst always taking your health into consideration? Everyone
will find the correct goal to follow in their training. but how do you train to achieve those goals in the most
efficient manner possible? How do you find the right intensity of effort during training? CICLO
InZone
®
is the
optimum training ZONE for effort, resistance and weight loss.
What does CICLO
InZone
®
do?
It calculates the optimum training zone for effort, resistance and weight loss. The values vary from person to
person and they offer a valid training support – always staying between 70 % and 85 % of the maximum
heart rate. (+/- 5 % of tolerance, taking into consideration the actual heart rate when at rest and the level of
training). The question of burning fat is seen in the “
correct
” light with CICLO
InZone
®
– on the basis of the
personal data collected.
4.7 Battery change
A
battery symbol
appearing on the left side of the middle display indicates that the battery is running flat and
a battery change is recommended.
Put the CM 9.3 A (+) into power saving mode (3.9.1). Open the battery cover with a coin and replace the
battery “
CR2032
“. before you close the battery cover,
make sure the O-ring is positioned correctly.
Otherwise, splash proofness may be compromised.
4.8 Service Interval
If “
SERVICE
” is displayed in the lower display after start up, your bike shop has set a mileage value in the
CM 9.3 A and recommends you to check with them for an inspection of your bike. Pressing the middle button
while SERVICE is displayed, turns this function off.
