CIAT DESTRATIFIER TPL 4000, Instruction Manual

Page: 10 / 24

6 - SETUP
Installation with wall-mounting kit + additional kit on IPN
IPN
Serrated washer L8 + H M8 nuts
H M8 x 70 screw + L8 plain washer
Plastic end piece
Support tube
H M8 x 50 screw
+ serrated washer
Mounting bracket
kit
Wall-mounting kit
Additional kit for IPN
Assembly procedure:
1. Pre-assemble the clamping plates on the brackets using
the Ø 8 mm serrated washers and the H M8 nuts (not
tightened).
2. Fit the bracket assemblies onto the support tubes by
sliding them over the end.
3. Fix the legs of the wall bracket (7181226) using the 4
H M8x70 screws, the 4 x Ø 8 mm plain washers, the 4
x Ø 8 mm serrated washers and the 4 x H M8 nuts,
allowing the distances detailed above.
4. Move the support assembly onto the IPN and slide the
bracket assemblies so that the lips are clamped onto the
IPN. Tighten the bracket nuts to lock the assembly in place.
5. Fix the HELIOTHERME unit using the 4 x H M8 x 50 screws
supplied with the wall bracket.
Size 4300 4350 4400 4450 4500 4630 4630S
Distance mm 512 558 610 710 808 943 943
Code for additional kit for fastening on an IPN
Reference 7181228 7181230
6.4 - Ceiling-mounted H4000 Heliotherme
Installation with ceiling-mounting kit
Installation only possible for HEATING applications.
Ceiling mounting using fluids at temperatures above
90°C is prohibited if the heat exchanger is still
supplied with fluid when the ventilation is switched
off. (Motor warranty invalidated if the motor is
damaged due to the thermal inertia of the coil)
To be provided by the client:
-
M8 threaded rods
-
Lock nuts underneath the inserts
Assembly procedure:
1. Remove the 8 x M8 screws. (Upper and lower section of the
HELIOTHERME)
2. Fit the ceiling brackets and refit the M8 screws in their original
locations.
Bracket identical on all
4 sides
M8 metric
screws
M8 insert
H4000 HELIOTHERME EN-10