Installation Manual
Page 30 of 42
CIAS Elettronica S.r.l.
20MACIE0186 Ed. S001
SIOUX LIGHT
LINE1
Description
VCC
Power supply output:13.8 V
GND
Ground
LH
RS485 High Line
LO
RS485 Low Line
SHLD
Shield
LINE2
Description
VCC
Power supply output:13.8 V
GND
Ground
LH
RS485 High Line
LO
RS485 Low Line
SHLD
Shield
LED Function
Description
POWER LINE1
Indicates the presence of power on VCC of LINE1
RX
Indicates message reception
TX
Indicates message transmission
LED Function
Description
POWER LINE2
Indicates the presence of power on VCC of LINE2
RX
Indicates message reception
TX
Indicates message transmission
On the rear plate, from the left are:
-
1 Audio Jack (
AUDIO
) actually
not active
.
-
1 Push button (
SET BUTTON
)
-
1 RS485 serial terminal block for the connection of the Sioux-CU to the IB-System or to
the relay cards (
LINE3
)
-
3 led associated with serial LINE3: from the top a green led which indicates the presence
of power on the serial port terminals (
POWER LINE3
), a yellow led which indicates the
presence of received data (
RX
) and another yellow led which indicates the presence of
transmitted data (
TX
).
-
3 dip switch for setting the serial line: polarisation and termination (
SET LINE3
)
-
1 connector for connection a 4 x balanced line expansion board
(
EXTERNAL BOARD CONNECTOR
) actually
not active.
-
1 green led which indicates the presence of power (
GENERAL POWER
)
-
1 two way terminal block for connection of a tamper contact
-
1 four way terminal block for power and power presence (
POWER
)
