CIANFLONE 2501XBT, Operation & Safety Manual

Page: 5 / 50

IMPORTANT NOTICES
i
Before operating the Portaspec, there are many operating procedures specified in
this manual that must be followed without deviation, to insure safe and trouble free
operation.
Carelessness in the application of these procedures can result in unsatisfactory
operation of the equipment, and possible inadvertent exposure to x-radiation.
Consequently, it is urged that the following material be given a careful reading by all
concerned with the operation and maintenance of the equipment.
1. X-RAY MONITORING & REPORTS
X-ray equipment can be dangerous to both the operator and persons in the
immediate vicinity, unless safety precautions are strictly observed.
It is strongly recommended and in some states mandatory, that the operator wear a
radiation film badge to record radiation exposure. This film badge may be obtained
for a minimal charge from many sources, one of which is listed below:
LANDAUER

, INC.
2 Science Road
Glenwood, Illinois 60425-1586
Telephone: 708-755-7000
2. PORTASPEC

MANUFACTURER
’S NOTICE
As a manufacturer of x-ray producing apparatus, we have attempted to provide all
the best technology and safeguards to protect the operator and surrounding persons.
There are governmental laws pertaining to the use of this equipment. Before it is
used in your facility, communicate with your State, Provincial or Federal Division of
Occupational Health, or similar agency, to determine what rules and regulations with
regard to the use, operation and registration of this apparatus may be applicable. In
addition, you should comply with all governmental regulations pertaining to this
apparatus. We warrant this instrument for all purposes for which it was intended
only. We will not be responsible for any injury or damage caused by improper or
negligent use or operation of this instrument, or for the violation by the owner or
operator of this instrument, of any regulations or laws pertaining to this type of
apparatus.
3.
MEDICAL NOTICE
Persons undergoing medical diagnostic tests that involve consumption or injection of
radioactive dyes, normally given for stress tests or cardiac catheterization tests,
should not be in the immediate area of the Portaspec while in operation. To do so,
could cause the Portaspec readings to be elevated and inaccurate until the radiation
dye is depleted in approximately 3 to 4 days.