17
6. Usage
6-7. Understanding the ice making process and operation
①
If power is supplied to the product by inserting the power plug, then ice making automatically
operates without any manual setting.
②
When the water level in the ambient water tank reaches to specific level, it starts to remove all the remaining
ice on the evaporator. This action is done when power is newly supplied to the product.
③
The compressor and ice making pump operate in order to make cold water.
(The cold water production process automatically operates according to designated programming.)
•
Cold water operation: Cold water is made by process of spraying water to evaporator.
Water temperature in the cold water tank is automatically detected by the sensor, and if it
drops below the set temperature, then the cold water operation will automatically stop.
④
If cold water production is done, ice making get started in accordance with the process of Ice forming and Ice
harvesting action.
•
Ice forming action: Spray cold water to the evaporator for given time.
•
Ice harvesting action: Supply heat to the evaporator to remove ice from the evaporator.
⑤
When the ice storage is full, the ice level sensor automatically sends the signal of stopping ice making process.
⑥
Chilly air is sent to the ice storage periodically to reserve temperature.
⑦
If ice in the storage is not used for long periods of time, it may melt, and small pieces of ice can be served
during ice dispensing.
※
TDS(Total Dissolved Solid) of ice may increase slightly according to the environment in which the ice is made.
•
The lower room temperature is, the shorter the ice making process will take and the higher room
temperature is, the longer the ice making process will do.
•
Do not install or use the product in temperatures below 32
℉
(0
℃
) or above 104
℉
(40
℃
).
●
Ice making system of the product starts and operates to make ice automatically according to
program set after power is ON.
T-461_영문매뉴얼_T_461_메뉴얼_5170S 12. 4. 10. 오후 4:32 페이지 18
