Chungho Iguassu ICE 500, User Manual

Page: 15 / 24

15
6 6.. U Ussa ag ge e
①
Turn on the drain switch located on the back of the product. Power must be
on for this function to operate. (Note: When drain switch is turned ON, water
purification and ice making are disabled.)
②
Dispense all ice by pressing the Ice dispensing button.
③ Remove the Lower panel by pressing down and pulling the cover outward.
(Note: May need to remove two screws on the bottom of the Lower
Cover.)
④ Unscrew both valves (cold and hot/ambient). (See diagram to the right)
⑤
After dispensing all water and ice from the product, make sure that all
valves are closed and the Lower panel replaced.
※
During transport, if the product needs to be tilted, make sure that the product
is tilted backwards, no more than 45 degrees.
6-6. Draining the System for Relocation/Installation
(1) Ice Dispensing Mode
If ICE(ice dispense) touch sensor button is pressed, the door of the ice
storage house is opened and ice comes out from the dispensing hole.
(2) Hot Water Dispensing Mode
If HOT(hot water selection) touch sensor button is selected and the
water dispensing button is pressed, hot water comes out.
※
Please be careful to avoid burns and use cups during hot water dispensing.
※
If hot water operation LED is turned off, hot water is not dispensed,
because the heater does not work.
(3) Cold water Dispensing Mode
If COLD(cold water selection) touch sensor button is selected and water
dispensing button is pressed, cold water comes out.
※
After early power ON water full LED is lighted up, cold water dispensing
selection is available.
(4) Ambient Water Dispensing Mode
If AMBI(ambient water selection) touch sensor button is selected and water
dispensing button is pressed, ambient water comes out.
※
If hot water or ambient water is selected and it is not used for a given time
period(Ambient : 10 second, Hot water 5 second) the system will automatically
switch into cold water dispense mode. (Default function)
※
There is not a separate setting and release method for the use of ambient
water/cold water/ice making operation. They operate automatically as
designated by the program when the power is supplied.
6-5. Ice and Water Dispensing Method
B
It enables to dispense Ice and Hot water when the Lock function is released.
※ If Lock function (of Ice and Hot water dispensing) is set, Ice dispensing and Hot water selection touch button
do not function. Please use it after releasing the Lock function.
Flushing Valve