Chrysler Voyager 2001, Operating Information Manual

Page: 89 / 168

Rotate the center knob on the front ATC control
unit to the “REAR CONTROL” position, this illumi-
nates an “UNLOCK” symbol in the rear automatic
temperature display. Rotate the rear blower con-
trol and the rear mode control to the “AUTO”
positions. Select the temperature you would like
the system to maintain by pressing the Rear
Temperature control button. Once the comfort
level is displayed the system will maintain that
level automatically.
CAUTION!
Interior air enters the Auxiliary Heater and Air
Conditioning system through an intake grille
located in the passenger side trim panel behind
the third seat. The heater outlets are located in
the passenger side trim panel just behind the
sliding door. Do not block or place objects
directly in front of the inlet grille or heater outlets.
The electrical system could overload causing
damage to the blower motor.
REAR WINDOW FEATURES
The controls for these features are located in the
middle of the instrument panel above the radio.
Rear Wiper Switch
Press this switch to have the rear wiper
have a continuous wipe. The switch posi-
tion as well as an indicator light will show
when the wiper is ON.
Intermittent Rear Wiper Operation
When this switch is pressed the rear
wiper will operate at a fixed interval of
about 8 seconds. As vehicle speed in-
creases, the time delay will shorten. The
switch position as well as an indicator light will
show when the wiper is ON.
Rear Washer Switch
Press and hold the switch as long as spray
is desired. If the switch is depressed while
the wipers are on, the wipers will operate
for a few seconds after the switch is
released then resume the previously set mode of
intermittent wiper or continuous wipe. If the switch
is depressed when the wipers are off, the wipers
will operate for two cycles, then turn off.
NOTE:
The washers will stop spraying if the switch is
pressed longer than 10 seconds.
88