Chronos Manufactures MLG-1103, Instruction Manual

Page: 11 / 93

Date and Time Settings
Pull the crown out to position 1. Turn it clockwise and set the date. Pull
the crown out to position 2 and set the time. Then push the crown ca-
refully back in.
Using the Chronograph
Basic function
Press button A to start and stop the chronograph. Press button B to reset
all chronograph hands.
Accumulated time measurement
Press button A to start or stop the chronographs. Press button A again
to resume the time and stop it once again. The time measurement can
continue to be accumulated in this way. Press button B to reset the chro-
nograph seconds counter and chronograph counters for minutes and
hours.
Split time measurement
Press button A to start or stop the chronographs. Press button B to dis-
play the split time (timing is running in the background). Press button B
to recover the measurement time (the 3 chronograph hands are quickly
advanced to the accumulated measured time obtained). Press button A
to stop the chronograph and display the end time.
Controlling the chronograph hands
To ensure that all chronograph hands are adjusted to their 0-position, a
full initialisation must be performed after setting the hand. Each counter
must be set once. For this, please pull the crown out to position 2, press
both buttons, A & B simultaneously for a minimum of 2 seconds. Then
set the chronograph seconds counter to 0. By pressing button B, you
can switch to the next counter. When you have gone through all the
counters, push the crown back in to its original position 0.
MLG-1103 Tableau du Bord
Movement: Quartz Swiss made
ATTENTION: Never set the date
between 9 pm and midnight since
it is possible that the date will not
change the following day. Exces-
sive acceleration in the big date‘s
quick fix can lead to an incorrect
date. Synchronisation can be res-
tored, however, by switching the
date from 01-31 (at position 2).
11
Instruction manual
EN