Instruction Manual
Vivid LX20 Mount
3
Surface Mount RPA
Install the RPA as follows:
1. Disassemble the RPA:
a. Remove four #10-24 X 3/8” long pan head roll adjustment
screws (see Figure 6).
b. Remove two #10-24 X 3/8” long pivot screws.
c. Remove the Ceiling bracket from the joint bracket (see Fig-
ure 7).
2. Secure the ceiling bracket to the wood framing member.
3. Secure the ceiling bracket to the joint bracket (see Figure 7)
using four #10-24 X 3/8” long pan head roll adjustment screws
and two #10-24 X 3/8” long pivot screws (see Figure 6).
4. Using four studs on mount and four thumb screws, secure the
RPA to the mount (see Figure 6).
5. If desired, route cables through RPA as shown in Figure 8.
Figure 6. RPA Screws
Roll Adj. Screws
Roll Adj. Screws
Pivot Screw
Pivot Screw
Ceiling Bracket
Joint Bracket
Adjustment Plate
Figure 7. RPA Disassembly
Roll Adjustment
Pitch Adjustment
Jam Nut
Figure 8. Adjust Yaw, Pitch, and Roll
