adjust projector settings
4
1
getting started
2
mount projection lens, get to know the connector panel
Carefully mount the projection lens. Remove protection end caps on lens and bayonet mount, then insert, and turn clockwise until it stops and a click sounds. The
connector panel at the back features a wide range of connectors for all sorts of source connections. Decide which one(s) that meet(s) your requirement(s).
This Quick Start Guide has been designed to help you quickly getting started using your new projector. If you require further help, or have questions on the details of
how to operate this unit, please refer to our web site in order to download the complete product documentation. You can also access FAQs and download detailed
white papers in order to get to know the more specific product features and benefits.
Packaging contents:
Adjust zoom to set correct image size, shift to position correctly, focus for clarity, and any other desired setting, such as tilt. Adjust image level with the front feet, and
tilt with the rear foot.
5
adjust image and system settings
connect sources, connect power, power on
3
E
Change and adjust settings such as brightness and contrast, ceiling mount and rear projection display, as well as colour calibration, and other system settings by
using the remote control or through the menu system that is accessible from the on-board keypad.
6
power off and allow to cool down
To power off, press the power (
) key once, and confirm by pressing again. Allow to cool down until all fans have stopped (a minimum of 30 seconds), and steady
amber indicator lights indicate the projector has been safely turned off. Disconnect any cables, sources and power cables before uninstalling the projector.
Make sure the projector is switched off, and not connected to power when connecting to sources. Connect video and computer sources, then insert the power
cable. Power up sources, including computers and video playback devices. Power up the projector by pressing the power key (
). A steady, bright indicator light
will indicate it is in operation. CAUTION! Connecting sources to a powered projector may result in product failure. It is recommended that the power cable connector
(projector-end) or the mains power socket are accessible whilst the product is in use to enable mains power to be disconnected or switched off when connecting
source devices. This should be considered during product installation.
>30 s
projector unit
A: Zoom B: Focus C: Shift
Press to activate. Adjust with arrow keys.
D: Lens shift (operated from back)
E: Adjustable feet for levelling.
D
remote control
power cable
product documentation
B
C
A
*
* 3D menu feature only appliable for Active Stereo 3D-enabled projectors (1080p and WUXGA).
601-0312-01
The cabinet colour may differ from the one shown in the pictures.
When referring to the term F85 in this document, it means that the content is applicable
for the following Barco products:
• F85 1080p
• F85 WUXGA
www.barco.com
Quick Start Guide
F85
Please visit our web site to download full user manual or find related information
