Christie DW6Kc, User Manual

Page: 78 / 177

Section 3: Operation
020-100001-01 Rev. 01 (04/07) 3-49 .
Figure 3.11. Using “Odd Pixel Adjustment”
NOTES: 1)
Adjust offset before gain, since offset affects gain.
2)
A value of 128
represents no change in normal odd pixel offset or gain.
3)
Odd Pixel Adjustment
eliminates “one pixel on, one pixel off” artifact only, not any type of larger artifacts.
Reserved
No function.
Peak Detector
The “Peak Detector” is a fast method for defining individual input levels, and can
improve the accuracy of input levels set by the Auto Input Level function. Enabling
the “Peak Detector” activates a special operating mode for detecting
only
pixels that
are considered black or white—all other levels are displayed as a mid-level gray.
When used with a 16-step grayscale pattern in which the two black and white bands
are known to be at opposite edges of the image, you can watch these isolated areas
while adjusting individual black levels and input drives until both bands are just
visible. Images from this source will then display correct blacks and whites without
crushing or washing out.
NOTE:
If using Peak Detector with PIP, both images must have the same color space.
Level Detector
The “Level Detector” checkbox enables specific thresholds for blacks and whites—
input levels that fall below a specified
Level Value
(see below) are displayed as black,
and all others are displayed as white. It aids in Odd Pixel Adjustment. To use:
1. Enable “Level Detector” and display a continuous grayscale.
2. Set “
Level Value”
to near black (such as 200).
3. Adjust Offsets to minimize area of black stripe.
4. Set “
Level Value”
to near white (such as 800).
5. Adjust Gains to minimize area of white stripe.
Level Value
Level Value
defines the value to be used by the Level Detector in recognizing blacks
and whites. See
Level Detector
, above.