Installation
GS Series (DHD599-GS, DWU599-GS) User Manual
30
020-001162-0
Rev. 1 (12-2017)
Removing and installing the lens
1.
Center the lens
: Ensure that the lens is at or near its center position. Attempting to remove
the lens when at a large offset may cause damage to the lens assembly. Center the lens while
the projector is switched on by pressing the lens horizontal or vertical button and then pressing
Enter.
2.
Turn Off the projector
: Turn the projector OFF.
3.
Wait for projector to cool down
: Allow the projector to cool down into standby mode before
replacing the lens. Remove power cord after the projector has cooled down and prior to
replacing the lens.
4.
Remove the lens
: Remove the lens ring cover. Rotate the lens counter-clockwise by a quarter
to release the lock. Remove the lens through the front of the projector.
5.
Install the new lens
: Fully insert the lens assembly straight into the lens mount without
turning. Rotate the lens cap clockwise to lock the lens in place.
Warning!
Failure to comply with the following could result in death or serious injury.
• Turn off the projector and remove the power cord, before installing or replacing a lens.
Summary of Contents for DHD599-GS
Page 1: ...GS Series DHD599 GS DWU599 GS User Manual 020 001162 0...
Page 103: ......
