Installation and Setup
D4K2560 Setup Guide
16
020-101171-04 Rev. 1 (01-2015)
Adjust the projector tilt and level
Adjust the projector tilt to fill the maximum amount of screen while minimizing keystone. Lens
offset can be used to center the image in the center of the screen..
1. Secure a safety lifting strap rated to handle the projector weight at the rear of the projector.
2. Hoist up the projector.
3. To adjust the vertical or horizontal position of the projector, extend or retract the adjustable
feet on the bottom of the projector (A).
4. Once the required adjustment is made, tighten the lock nut
against the bottom of the projector (B).
The projector provides 4 inches of adjustment at the front and
11.5 inches of adjustment at the rear.
5. If the vertical or horizontal position of the projector requires more
adjustment than the standard feet allow, two 6-inch extension
rods can be installed to increase the amount of available
adjustment.
Install the foot extension rods
1. Elevate the rear of the projector to access the two rear feet.
2. Remove the feet by loosening the lock nut and rotating the each foot out of the projector.
3. Add the extension rods to the standard feet.
4. Thread the extended feet into the projector’s baseplate.
5. Adjust the feet until the required tilt is achieved.
Warning!
Failure to comply with the following could result in death or serious injury.
• The projector’s rear safety strap must be in place before adjusting the projector feet.
• Do not over-extend the feet. Make sure several threads are engaged into the projector’s baseplate
to secure the projector from falling.
Notice.
Failure to comply with the following may result in property damage.
The front-to-back tilt of the projector must not exceed 15 degrees.
A
B
