Christie CP2000-XB, Setup Manual

Page: 14 / 66

2-4 CP2000-XB Setup Guide
020-100250-02 Rev. 1 (06-2009)
Section 2: Installation & Setup
STEP 7 - Ignite the Lamp and Select the Source
At the TPC Main menu, press the lamp button and hold for two seconds to ignite the lamp. Press the desired
channel button on the Main menu. The source will be displayed according to pre-defined factory defaults for
this channel. Adjust or apply new settings as described in Section 3 Basic Operation .
STEP 8 - Adjust the Lens
Turn the focus knob to sharpen the image. Adjust the zoom ring on the lens to increase or decrease image size.
If desired, use the horizontal and/or vertical offset knobs to shift the image location. For other lens functions,
refer to
Section 2.11 Offset and Boresight Alignment .
2.2 Installation Considerations
Although the CP2000-XB is carefully engineered to deliver an exceptional quality high-brightness, high-
resolution output, your final display results could still be compromised if the projector is improperly installed.
This subsection discusses issues to consider before proceeding with a permanent installation. Read through to
understand how good positioning will help ensure optimized images at any site.
2.2.1 Screen Types
Front Screen Installations
This projector is intended for use with flat or slightly curved screens, front or rear, ranging from about 5 meters
(16 ft.) to 25 meters (82 ft.) wide. Although flat screens generally offer a low gain similar to a matte white wall
paint—approximately 1 with a viewing angle just under 180°—and are considered most effective when
ambient light is low, this difference in gain may be negligible given the very high light output from this
projector. In addition, incident light reflects equally in all directions so the audience can see the display from
more acute viewing angles. See
Figure 2-8 .
NOTE
: CP2000-XB high-contrast lenses are designed primarily for use with flat screens, but the projector’s
depth-of-field range allows the lens to be focused on mildly curved screens as well. While focus remains sharp
in the corners, there may be significant pincushion distortion, primarily at the top of the screen.
Figure 2-8 Audience Coverage with a Flat Screen