4
CHRISTIE DIGITAL SYSTEMS
CineX35 Projector
4-1
May, 2004
4 .
O P E R A T I N G T H E P R O J E C T O R
4.1. G
E N E R A L
Before operating the projector, verify that all phases of installation and assembly have been
completed.
WARNING
•
Verify that cover for belt side of projector is installed before and
during operation.
•
Do not make adjustments on belt side of projector while cover is
removed and power is on.
•
Do not make adjustments or perform maintenance on projector
while it is in operation.
4.2. P
R E
-O
P E R A T I N G
P
R O C E D U R E S
4 . 2 . 1 . F
L Y W H E E L
I
N S T A L L A T I O N
1. Back out flywheel set screw far enough to let flywheel slide onto shaft without scoring
shaft or damaging threads on set screw.
2. Slide flywheel onto shaft until it stops.
3. Position set screw over flat portion of shaft and tighten set screw.
4. Spin flywheel by hand to check for smooth operation.
CHRISTIE
recommends that any projector accessories be installed at
this time.
4.2.2.
L
E N S
I
N S T A L L A T I O N
1. Install lens system in lens holder. If it is necessary to open lens holder wider than
normal:
a) Loosen two lens-locking screws.
b) Turn jack screw clockwise until lens slides into lens holder; turn the screw back.
2. Set focus knob at mid-position.
