NET–Network Setup
Modifies the network setup for this device.
By default, DHCP support is turned on.
Commands
Command
Description
Values
NET "<ip>" "<subnet>"
"<gateway>"
Sets the projector network settings as specified. (Saved
value)
All three arguments are
strings and the gateway is
optional.
NET+DGRP "<group>"
Sets the device group name for the projector. (Saved
value)
This can help simplify broadcast searching by
organizing projectors into groups, particularly if a large
number of projectors are on the same local network.
group = Group name for
the projector
NET+DHCP 1
Enables DHCP. To turn off DHCP support, switch to a
static IP by using the base command. (Saved value)
1
NET+ETH0?
Returns the projector IP address. (Read-only)
—
NET+GATE?
Returns the projector gateway address. (Read-only)
—
NET+HOST "<name>"
Sets the name for the projector. (Saved value)
With this set, devices on the same network subnet as
the projector can connect to it using the name:
<name>.local.
name = Name for the
projector
NET+MAC0?
Returns the MAC address of the Ethernet port. (Read-
only)
—
NET+PORT?
Returns the TCP port used for the Christie serial
protocol over Ethernet. (Read-only)
1024 to 49151 (with some
exceptions)
3003 = Reserved on the
projector and cannot be
used for the Christie serial
protocol
NET+SUB0?
Returns the projector netmask. (Read-only)
—
Examples
Set the static IP address to 192.168.1.100, with a netmask of 255.255.255.0, and no gateway:
(NET "192.168.1.100" "255.255.255.0")
Turn on DHCP support:
(NET+DHCP 1)
Serial API commands
Christie Technical Reference–Serial Commands
46
020-103316-07 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
