VER.1.3
PULSE OXIMETER OPERATOR＇
S MANUAL
18
E04
Sensor is unplugged
E05
No finger or sensor problem
E06
Searching for pulse
E07
Searching too long
Low priority
E08
Lost pulse alarm
Note: The symbol “Beep off” indicates no selection for voice.
When the E9, E10, E11 or E12 occurs, the value of the LED
displays will flash.
z
Check the error code
Press right key under initial display mode, it will indicate error code if
there have. If want to return initial mode please press menu keypad
again.
Warnings!
When alarm occurs, check patients’ conditions immediately.
z
Check which parameter is alarming or which alarm is going on.
z
Check patient’s condition.
z
Search for the source of alarm.
z
Make the alarm mute if necessary.
z
Check the alarm when no warning.
9 Beep on/off
Press the menu key five times under the
interface of initial display mode to enter access
to this function, associated display shown as
below.
Press up or down key to set the speaker on/off.
10Maintain and Repair
10.1 Maintenance
It is very important for user to make daily maintenance of oximeter and
Fig.15
Summary of Contents for MD300K
Page 1: ......