Chippmann CS-8 DST2, Owner'S Manual, Page: 12 / 16

CS-8 Series DST2 Rev1.0, Dec. 2018
-10-
7.3 Initial operation
The power connector’s
(1) pin-out in top view (refer to fig. 2) is assigned as
follows:
Bottom to top, left to right. Thus pin 1 is located at bottom left, pin 2 above pin
1 etc. Pin 15 is at bottom right, pin 16 at top right.
Pin 1, 2 = -12 V (labelled with a triangle)
Pin 3-8 = GND (ground, 0 V), located outward on all jacks
Pin 9, 10 = +12 V
Pin 11-16 = not in use
To hook up power to the module, connect one of the IDC-jacks of the included
flat ribbon cable to the connector (refer to fig. 2). Observe guide key for the
polarity of the connector in ord er to avoid pin reversal. The
red tag of the
cable is to match the triangle-label .
8. MODULE DESCRIPTION
Structure
Distortion
Distortion
LP
HP
Fig. 3 Structure of DST2
Fig. 3 shows the structure of the distortion unit. The input signal will be
spectral separated by a high-/low-pass crossover network at 113 Hz before
feeding the respective distortion stage and mixing the results together.