![Chinavision RX102 Device Manual Download Page 10](http://html.mh-extra.com/html/chinavision/rx102/rx102_device-manual_2602107010.webp)
10
will reply “timezone: ok with -8”
。
9.
Geo-fence:
This command is to set an electronical fence. If this command has been set, an alarm will be
reported to user when the device is out of the fence.
Setup a Geo-fence:
Command:
The user can send SMS “stock+pspace +lat0,long0+space+lat1,long1” to
the tracker device to set the restricted district. [lat0] and [lon0] indicate the latitude and longitude
of the start point (the top left corner of the Geo-fence) respectively, and [lat1] and [lon1] indicate
the latitude and longitude of the end point (the bottom right corner of the Geo-fence) respectively.
Alarm:
When the terminal moves out of the fence, the tracker device will send a SMS “stock
+current Geo-info” to the authorized telephone numbers in 3 minutes interval repeatedly.
Example:
Send a SMS “Stock123456 22.11,113.11 25.11,115.11”to the
tracker device. If the terminal moves out of the fence, the tracker device will reply a SMS
“
stockad alarm lat:22.55334 log:113.903418”
。
Attentions:
The first latitude & longitude is coordinate of the top left corner of the Geo-fence, while the second
latitude & longitude is the coordinate of the bottom right corner;
The alarm will repeat in 3 minutes interval when triggered.
This command is recommended to set when the device stays immobile in a place.
If this command is received when an electronic fence was already set, the new fence will replace the
old one.
Cancel a setting Geo-fence:
Command:
Send SMS “password” to deactivate this function.
10.
Moving Alarm
Setup moving alarm:
Command:
When the vehicle stays immobile in a place and the engine is off, the user could send
a SMS “move+password” to the tracker device to setup a moving alarm. The command can only
take effect only when the device can get the precise latitude and longitude of the current position.
Responses
: The device will reply “move OK” to indicate move alarm setting successfully. Other
possible error responses are
—
“move : error for no master set.”
—
“move : error for current position is not accurate.”
Alarm:
In case of such a movement (the default distance is 200m), the device will send an alarm
SMS “Move + current Geo-info” to the authorized numbers in 3 minutes interval repeatedly.
Example:
Send SMS command "move123456" to the tracker device .
Cancel moving alarm:
Command:
Send SMS “password” to deactivate the movement alarm.
Example:
Send SMS command "nomove123456" to the tracker device
11.
Overspeed Alarm
Setup overspeed alarm
Command:
Send SMS “speed+pspace+speed_limit_value” to the device to set the
overspeed alarm. After the setup, the speed alarm will be triggered and reported to the user if the
vehicle’s speed exceeds the speed limit. “Speed limit” in command is an integer value (60~360)
with the device km/h.