5
Step 4. Removing the Tube or Plug
•
Make sure to completely eliminate all pressure before removing
the tube from the Quick Connector Union fitting.
•
Turn off the incoming feed water and open the faucet.
•
When removing the tube or plugs, push and hold the collet clip
in against the fitting as you pull the tube or plug out. This
releases the tube or plug.
•
Fittings and tubes can be reused. Be sure to check for possible
scratches on the tube when reusing.
8.
PRIMARY COMPONENTS DIAGRAM
9.
ADJUSTING THERMOSTAT
The thermostat is factory preset and requires no adjustment other than for
abnormal requirements. If needed, the water temperature can be adjusted by
turning the screw on the cold water thermostat as located in the diagram above. Use
a small straight blade screw driver. Turn clockwise to make colder. Turn
counterclockwise to make warmer. Do not force the turning pressure to the
thermostat with the screwdriver, as excessive force can damage the thermostat.
Caution:
Adjusting the
thermostat should be performed by a professional. Adjusting the thermostat too cold may cause the
Chiller to freeze up.
