Installation Instructions
WM110S-120S-130S
11
Figure 18
3.
Install interface and projector to RSA according to RSA
installation instructions.
Removing Mount Covers
1.
Remove two #8 x 1/2" Phillips pan tapping screws (T) and
two #10 x 1" Phillips pan tapping screws (U) to free top cover
(C) and expose pitch adjustment screw. (See Figure 19)
2.
Remove lower cover (D) from WMA1S. (See Figure 19)
Figure 19
Pitch Adjustment
1.
Loosen two 5/16 x 1/2" hex head screws (S) (one on each
side of wall bracket). (See Figure 20)
2.
Loosen two bolts (one on each side of pitch adjustment
screw). (See Figure 20)
3.
Adjust pitch adjustment screw until mount is at desired pitch
level.
•
Turn
clockwise
to raise mounting level.
•
Turn
counterclockwise
to lower mounting level. (See
Figure 20)
4.
Tighten two bolts (one bolt on either side of pitch adjustment
screw). (See Figure 20)
5.
Tighten two 5/16 x 1/2" hex head screws (S) (one on each
side of mounting bracket). (See Figure 20)
Figure 20
6.
Return mount covers to the mount following instructions in
Installing Mount Covers
section.
Cable Management (Optional)
NOTE:
In most cases, the cable management cover will NOT
need to be removed in order to route cables from
projector to the wall mount. But for some thick cables,
removing the cover may be necessary.
NOTE:
Remove mount covers from the mount following
instructions in
Removing Mount Covers
section.
1.
Remove cable management covers (if necessary) from
short throw projector arm. (See Figure 21)
RSA
mounting plate
(R) x 4
2
(U) x 2
1
1
1
(T) x 2
2
(D)
(C)
1
5
2
4
or
3
Raise
Lower
Pitch
adjustment
screw
(S) x 2
