WM110S-120S-130S
Installation Instructions
8
8.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 8)
9.
Repeat Steps 5 through 8 for each mounting hole.
Figure 8
10. Place wall bracket over anchors and align mounting holes
in display mount with holes in anchors. (See Figure 9)
11. Insert 1/4-20 x 1-3/4" Phillips pan head screws (H) through
1/4" washer (G), corresponding mounting hole on wall
bracket and into anchor (J) and tighten until flush against
mount. DO NOT overtighten! (See Figure 9)
12. Repeat Steps 10 through 11 for remaining 2 mounting
holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 9
Installation to Wall Bracket
1.
Lift WM1XXS assembly (A) up to wall bracket (B) and hook
upper plate over upper notches on bracket. (See Figure 10)
2.
Slide lower plate into lower notches on bracket. (See
Figure 10)
Figure 10
3.
Fasten WM1XXS assembly (A) to wall bracket (B) using two
5/16 x 1/2" hex head cap screws (R) through two 5/16"
washers (Y), the wall bracket and WM1XXS. (See Figure 11)
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
8
Steel Stud
(side view)
Drywall
Anchor Metal Channel
Wall bracket
(H) x 3
11
Steel Stud
(G) x 3
(side view)
Upper plate
(A)
Lower plate
1
1
2
(B)
