TIL1X2UU / TIL1X3UU / TIL1X4UU / TILVABUU
Installation Instructions
8
Adding Side Connectors
NOTE:
To assist in mount installation, install the side
connectors BEFORE the mounts are attached to the
wall.
NOTE:
When installing the mounts
from left to right
, all side
connectors should be attached to the
RIGHT
side of
the mounts. The last mount will not require any
brackets.
NOTE:
When installing the mounts
from right to left
, all side
connectors should be attached to the
LEFT
side of the
mounts. The last mount will not require any brackets.
NOTE:
When installing the mounts
from the center
of the
video wall all side connectors should be attached on
BOTH
sides of the
center
mount.
•
For remaining mounts, connectors should be
attached on the
RIGHT
side of the mount for all
mounts installed to the
LEFT
of the center mount.
•
For remaining mounts, connectors should be
attached on the
LEFT
side of the mount for all
mounts installed to the
RIGHT
of the center
mount.
1.
Attach two horizontal connectors (A) to each wall mount
using two 1/4-20 x 1/2" button head cap screws (B) per
horizontal connector. (See Figure 4)
Figure 4
Assessing the Installation Site
IMPORTANT ! :
The top of the LED panel is 4" above the
top of the
UPPER
mounting slots, and the bottom of the
LED panel is 6" below the top of the
LOWER
mounting
slots. (See Figure )
NOTE:
If desired, the mount installation may be started in the
middle of the video wall, attaching mounts out from the
center to the left and right ends. (Review
Site
Assessment
section for further information.)
Installation on smaller walls may be easier if started at
the left or right side of the video wall using the following
instructions.
1.
Determine top or bottom panel height location and
horizontal placement of mounts.
2.
Make a mark 4"
below
the planned top edge (or 6"
above
the planned lower edge of the LED wall. (See Figure 5)
3.
Using a level, mark a horizontal line across width of LED
wall from the mark made in Step 2.
NOTE:
This line will be located at the top of the mounting slots
across the width of the LED video wall. The oversize
mounting slots will allow some upward adjustment as
needed. (See Figure 5)
Figure 5
1
(B) x 4
[TIL1X2UU shown as example]
(A)
Just a tip -
It is often a good idea to review
installation instructions and dimensional drawings
(at end of instructions), and then utilize masking
tape to lay out the entire LED video wall to lessen
the chance of any surprises later in the installation.
4”
6”
6”
4”
Bottom of LED cabinet
Top of LED cabinet
[TIL1X3UU mount shown as example]
2
2
3
Horizontal
mark through
top of mount
slots
