Installation Instructions
TIL1X2UU / TIL1X3UU / TIL1X4UU / TILVABUU
19
6.
While installing the cabinets, occasionally check to be sure
the connector fit and easily slide into place.
7.
Do
NOT
permanently connect the cabinets until they all
have been installed.
8.
Install the second column in the same way as the first
column, and be sure everything goes together smoothly.
9.
Push the second column to the left until it just touches the
first column. Do
NOT
slam the cabinets together.
10. Continue until all of the cabinets have been installed.
Connecting the Cabinets
11. Install two 10-24 x 1-1/4" Phillips head self-tapping (D) right
stop screws into the right side of each cabinet after the
cabinets have been connected together.
12. Tighten right stop screws until contact is made with the
mounting button on the cabinet. (See Figure 26)
Figure 26
Just a tip -
When installing the cabinets do not
force them together. If the alignment needs
correcting the plumb may need to be adjusted or
there may be interference somewhere in the
installation. Adjust as necessary.
Just a tip -
After all the cabinets have been
installed, connect the cabinets together.
When connecting the cabinets, start at one point
(preferably the
lower left corner of the LED wall
)
and work your way outwards.
Do not connect the cabinets together at multiple
points on the wall because this may cause the
connectors to pull the cabinets in different
directions when the connectors are tightened.
Make sure the front plane of the cabinets are
aligned since any misalignment will create
problems when the LED panels are installed.
(D) x 2
12
[View from
behind mounts]
