Installation Instructions
TIL1X2UU / TIL1X3UU / TIL1X4UU / TILVABUU
17
Connecting Mounts Above or Below First Row
•
Hanging Mounts from an Upper Row
1.
Hang the lower mount on the partially installed
Phillips head screws (M) in the vertical connectors
(L). (See Figure 21)
2.
Tighten both lower screws (M) on both vertical
connectors (L). (See Figure 21)
Figure 21
•
Installing Mounts onto a Lower Row
3.
Make sure the 1/4-20 x 1/2" Phillips head screw
(M) is already loosely installed in the vertical
connector (L) on both sides of the mount. (See
Figure 22)
4.
Slide mount down onto the screws so that upper
mount hangs on lower mount.
5.
Install two 1/4-20 x 1/2" Phillips head screws (M)
into upper hole on both vertical connectors, and
tighten all screws. (See Figure 22)
6.
Place a long level against front of the mounts and
adjust the depth of the newly attached mount to
align it with the first, installed mount.
7.
Adjust the leveling feet on the newly installed
mount so that they are touching the wall.
8.
Drill pilot holes in centerline of each mounting slot
on each leveling foot of the added mount (see
Table 1 for size) and follow fastener information
(appropriate for wall type) located in Table 1. (See
Figure 23)
Figure 22
9.
Double check the level of the mount at the bottom of the
teardrop slots, and make sure the new mount stays
perfectly aligned with the upper or lower mount to which it
was attached. (See Figure 23)
10. Fully tighten the 5/16 x 2-1/2" lag screws (F) through the 5/16"
fender washers (K). (See Figure 23)
Figure 23
11. Continue on until the entire LED wall is assembled.
Installed
mount
1
(L)
Lower
mount
(M) x 2
2
(L)
(E) x 2
5
Hang mount
3
4
Installed
mount
on loosely
installed screw
Lower
mount
10
(K) x 4
8
x 4
9
(F) x 4
