SLEU
Installation Instructions
6
Figure 4
SLEU POWER and CONTROL CIRCUIT
INSTALLATION
1/4" threaded Rod Installation
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installers responsibility
to make certain the structure to which the lift is being
mounted is capable of supporting 5 times the weight of the lift
and all attached equipment.
WARNING:
LIFT WEIGHS IN EXCESS OF 65 LBS
(30KG)! ALWAYS use two people and an appropriate lifting
device, and proper lifting techniques when installing or
handling this lift.
The SLEU is designed so that it can be installed by being
suspended from three 1/4-in.-dia. threaded rods (not supplied)
that have been secured to a structural cross brace in the ceiling.
1.
Carefully determine the position of the ceiling opening, and
its distance from (throw distance) and orientation to, the
target.
2.
Prepare an opening in the ceiling using the dimensions
shown in figure 2.
3.
Using two people, orient lift so that flanged side is at top and
place it on a flat surface capable of supporting the lift.
4.
Remove four caps on lift pan and set aside for re-use.
5.
Remove four Phillips pan head screws securing pan to lift
and set aside for re-use. (See figure 5)
6.
Lift pan off lift and set aside.
Figure 5
7.
Install threaded rods to structural cross braces in ceiling.
NOTE:
Installing turnbuckles on the threaded rod will make it
easier to level the lift.
x4
x4
Lift Pan
Flange UP
