QMP2MM1
Installation Instructions
4
ASSEMBLY
The QMP2MM1 is designed to be attached to Chief carts and
stands.
1.
Slide cart/stand bracket (B) onto cart/stand column (not
included), ensuring that cart/stand bracket tab slides into
the front of cart/stand column. (See Figure 1)
2.
Fasten the bracket to the cart/stand using four 5/16-18 x 5/8"
button head cap screws (K). (See Figure 1)
Figure 1
3.
Attach assembly bracket (C) to cart/stand bracket (B) using
two 10-24 x 1/2" button head cap screws (J) and two #10 flat
washers (L) through the top two holes in the assembly
bracket. (See Figure 2)
Figure 2
IMPORTANT ! :
If the display being installed has a
recessed mounting surface, the display must be
assembled to the mount prior to mount installation. See
Display Installation
section before proceeding.
4.
Insert top of height-adjust assembly (A) over lip on top of
assembly bracket (C). (See Figure 3)
Figure 3
5.
Swing height-adjust assembly (A) down flush against
assembly bracket (C). (See Figure 4)
Figure 4
1
2
(K) x 4
Cart/stand
column
(B)
(not included)
3
(J) x 2
(C)
(L) x 2
(B)
(C)
(A)
4
(C)
(A)
5
