QMP2MM1
Installation Instructions
6
4.
Position display with faceplate attached above mount. (See
Figure 9)
5.
Slide faceplate onto mounting head until quick release tab
clicks into place. (See Figure 9)
Figure 9
Adjustments
Pitch Adjustment (non-array models)
1.
Adjust pitch to desired tilt position. (See Figure 10)
2.
Adjust pitch tension screw to change the adjustment
tension. (See Figure 10)
Pivot Adjustment (non-array models)
3.
Adjust pivot position as desired. (See Figure 10)
4.
Use 3/16” hex key (M) to adjust pivot point tension screws
to change pivot adjustment tension. (See Figure 10)
Figure 10
Rotational Adjustment
NOTE:
(Optional) Rotational adjustment may be locked by
installing rotational locking screw (H) into back of
faceplate. (See Figure 11)
Figure 11
5.
The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
10)
6.
Use 3/16” hex key (P) to adjust rotational adjustment screw
to adjust rotational tension. (See Figure 10)
Lift Arm Tension Adjustment
1.
Tension may be adjusted with tension adjustment screw
inside cable management cover and 1/8” hex key (Q). Turn
clockwise to reduce tension or counter-clockwise to
increase tension. (See Figure 12)
Figure 12
5
pitch
pivot point
tension
tension
5
1
3
Rotational tension
6
(H)
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
