Installation Instructions
QMP2MM1
5
6.
Tighten set screw using 5/32" hex key (N). (See Figure 5)
CAUTION:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Make sure set
screw engages back side of assembly bracket on cart/stand
column. (See Figure 5)
Figure 5
DISPLAY INSTALLATION
Display Installation
1.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 6)
Figure 6
2.
Carefully place display face down on protective surface.
3.
Connect faceplate to display
For flush mounting hole installation:
•
Using Phillips screwdriver, carefully install four
M4x14mm screws (D) through corresponding
holes on faceplate and into the mounting holes on
the display. (See Figure 7)
Figure 7
For recessed mounting hole installation:
•
Place four spacers (F) on top of mounting holes
on back of display. (See Figure 8)
•
Using Phillips screwdriver, carefully install four
M4x25mm screws (E) through corresponding
holes on faceplate, spacers (F) and into the
mounting holes on the display. (See Figure 8)
Figure 8
Cart/stand column
(A)
(C)
quick release lever
1
1
(for flush mounting holes)
(B) x 4
quick release
faceplate
3
(for recessed mounting holes)
(C) x 4
(D) x 4
quick release
faceplate
3
