![background image](http://html.mh-extra.com/html/chief/pxr/pxr_installation-instructions-manual_2600945012.webp)
PXR
Installation Instructions
12
WARNING:
INSTALLING THE PXR IN UNDERRATED OR
DAMAGED CONCRETE CAN LEAD TO SERIOUS INJURY
OR DAMAGE TO PRODUCT! When installing into concrete,
only install the PXR in a solid concrete wall made of 2500 PSI
(17.3 MPa) or stronger concrete. Never install the PXR into
cracked, chipped or flaking concrete.
1.
Determine point for lowest edge of PXR.
2.
Use a level to mark the lowest edge of PXR. (See Figure 10)
3.
Place mounting bracket (X) along marked line on top of
level, and mark location of pilot holes. (See Figure 10)
4.
Drill two 5/16" x 3-1/4" (M8 x 82.5mm) pilot holes at
locations marked in Step 3. (See Figure 10)
Figure 10
WARNING:
ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before cutting, drilling, or
installing fasteners.
WARNING:
EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.
IMPORTANT ! :
The anchors must be installed through
any wall covering until flush with the concrete wall. (See
Figure 11)
Figure 11
5.
Install two anchors (RA) into pilot holes. Tap with hammer
until flush with concrete surface. (See Figure 12)
6.
Attach mounting bracket (X) to wall with two 5/16 x 2-1/2"
lag screws (RC) and two 5/16" flat washers (RB). (See
Figure 12)
Figure 12
7.
Lower PXR (Q) onto mounting bracket, ensuring PXR fits
over mounting bracket (X) tabs. (See Figure 6)
INSTALLING TO A SOLID CONCRETE WALL
X
X
Lowest edge
of PXR
3
2
x 2
(X)
4
9.19"
[233mm]
9.93"
[252mm]
center of
display
Wall
covering
Concrete
wall
Anchor
flush with
concrete
wall
Mounting
Bracket (X)
Pilot hole
5/16" x 3-1/4"
(M8 x 82.5mm)
Anchor
(RA)
Screw (RC)
Washer
(RB)
6
(RC) x 2
(X)
(RB) x 2
(RA) x 2
5