PXR
Installation Instructions
22
CAUTION:
ENSURE INTERFACE BRACKETS ARE
LOCKED TO THE PXR RAILS BEFORE BEGINNING
LEARNING MODE! The display must be centered on the
PXR so that the learning mode can be completed
successfully.
NOTE:
The
LEARN MODE
is used to calibrate the PXR for use
with the specific display which has been attached to it.
•
If the process is cancelled at any point during
Phase A or B it will need to begin again from
Phase A.
•
To exit
LEARN MODE
, press and hold
[STOP]
for 7 seconds. If no other errors are found, the unit
will flash 5 times indicating it must go through the
LEARN MODE
.
•
LEARN MODE Phase A
Phase A of the
LEARN MODE
helps the PXR
"learn" the amount of resistance caused by the
weight of the attached display.
Phase A will be
automatically run by the PXR.
1.
Press and hold
[SAVE]
for at least 5 seconds,
followed by
[STOP]-[RETRACT]-[PAN
RIGHT]-[EXTEND]-[PAN LEFT]-
[RETRACT]-[EXTEND]
to begin
LEARN
MODE Phase A
.
PXR moves through several cycles of extending,
retracting and tilting before stopping.
End of LEARN MODE Phase A
[The PXR should be fully extended, centered,
and tilted slightly at the end of
LEARN MODE
Phase A
.]
•
LEARN MODE Phase B
NOTE:
During Phase B Mode only the
[PAN LEFT]
and
[PAN RIGHT]
buttons will be active.
Phase B of the
LEARN MODE
helps the PXR
"learn" the dimensions of the attached display.
NOTE:
The PXR will operate at a slower than
normal operating speed during
LEARN MODE
Phase B
.
NOTE:
PXR should be fully extended and tilted
slightly.
1.
Pan PXR to left until the inside edge of
display is at least 2" away from the wall. (See
Figure 40)
Figure 40
2.
Press and hold
[SAVE]
for at least 5 seconds
to save left side dimension. [PXR will now
pan to center and remain tilted and
extended.]
3.
Pan PXR to right until the inside edge of
display is at least 2" away from the wall. (See
Figure 40)
4.
Press and hold
[SAVE]
for at least 5 seconds
to save right side dimension.
The PXR pans to left limit, back to right limit,
repeats, tilts up and returns to HOME position
before stopping.
End of LEARN MODE Phase B
IMPORTANT ! :
The
LEARN MODE
should now be
complete, and all values learned are now committed to
the PXR memory.
NOTE:
Each time the PXR loses power it will automatically
recalibrate its position by going to the
factory-set
HOME
position. Press any button on the remote control
after the unit has regained power to start the automatic
recalibration.
NEVER restrict the PXR from going to
the HOME position.
Saving a Preset
1.
Use remote control to move PXR to desired
position.
2.
Press and hold
[SAVE]
for at least 5 seconds,
and then the desired preset button
[I], [II], [III]
or
[IV]
.
Wall
Panned fully right
Panned fully left
1
3
2"
MINIMUM