Denar® Universal Occlusal Stand
For mounting the working casts
at Bonwill’s Equilateral Triangle
on Denar, Hanau, and Whip Mix
articulators.
Includes two interchangeable tables:
Flat table for mounting; also accepts Kois Index
Tray from Panadent.
Curved table for mounting.
Both the flat and curved table may sit flat or at a 10 degree
angle. Only a small height adjustment is needed to set
either position at Bonwill’s Triangle.
The universal occlusal stand fits the Mark 300 magnetic
series articulators, the Denar and Hanau screw type
articulators, and the Whip Mix articulators with Quick
Mount magnetic system.
Product Includes:
• Occlusal Stand • 2 Taper Pins (for using on Mark 300 series)
• Denar / Hanau Thread Adapter • Two Tables: Flat and Curved
• Fence in Bag • Instructions • 1⁄8” Hex Key
• 5/64” Hex Straight Wrench
Denar®
Universal Occlusal Stand
Instruction Manual
Whip Mix Corporation
361 Farmington Avenue
Louisville, KY USA 40209
Toll-Free: 800-626-5651
Phone: 502-637-1451
Fax: 502-634-4512
www.whipmix.com
Whip Mix®, Denar® and logos are registered
trademarks of Whip Mix Corporation.
©2019 Whip Mix Corporation
FN 20011719-F AE R1119
Flat or Curved Table:
Using the top set screw and 1/8”
Hex Key, loosen the screw until
you are able to remove either
the flat or curved table. Set in
the table you choose to use, and
tighten the top set screw.
Bonwill Settings:
Mounting without Kois
Index Tray
Using the front set screw on
the bottom cylinder and 5/64”
straight wrench, loosen the
screw until you are able to
move the middle cylinder up
and down.
Set the middle cylinder at its highest point and lock
into place.
Mounting with Kois
Index Tray
Use the flat table with the
angle set to 0˚ (flat).
Using the front set screw
on the bottom cylinder and
5/64” hex wrench, loosen
the screw until you are able
to move the middle cylinder
up and down. Set the middle
cylinder at its lowest point
and lock into place.
Adust the top cylinder to
the “0” setting for either the
Denar/Hanau or Whip Mix
articulator depending on
which you are using.
(See page 4.)
Attach Kois plate through holes in the mounting plate.
Table Angles
The table may be set at
either a flat (0˚) angle or
10˚ angle. Using the Flat
Head screw on the side
underneath the table and
the 1/8” Hex Key, loosen
the screw until you are
able to freely move the
table to a flat or angled
position. Set the table to
the desired position and
secure by tightening the
Flat Head screw.
Set
Screw
Set
Screw
Top Set
Screw
Flat Head
Screw
1
2
3
