Installation Instructions
Model PDR™
7
Adjust Height on the PDR
NOTE:
Height adjustment range up to 1-1/4 inches.
To adjust the PDR height:
1.
Check PDR for the desired height. If needed, use the
adjustment wrench (provided) to adjust the PDR
height.
•
Turn adjustment nut (See figure 4) clockwise
(CW) to lower the unit height, or
•
Turn adjustment nut counterclockwise (CCW) to
raise the unit height.
Install Cover Plates and End Caps
NOTE:
The cover plates and end caps have pressure
fitting ends that lock in place with each other.
1.
Install cover plate (20) over the top bracket (see
Figure 5).
2.
Install end cap (30) on the cover plate (20).
3.
Repeat steps 1 and 2 for the bottom mounting
bracket.
Figure 4: Adjust PDR Height
Figure 5: Install Cover Plates and End Caps
Adjustment Nut
Cover Plate (20)
End Caps (30)
Bottom Mounting Bracket
